 |
 |
 |
|
Save time and money with Andis® CeramicEdge™ Blades. The high-quality ceramic cutters on these blades stay sharper longer and require less sharpening than standard steel blades. The low heat transfer and friction index of ceramic keeps blades running 50% cooler than steel.
You'll use less coolant and clip faster with less downtime for increased productivity. Because ceramic blades do not heat up, they reduce the risk of friction burns. Steel combs have a Rockwell Hardness of 65. Compatible with Andis®, Conair®, Oster®, and Wahl® detachable clippers.
Size 40 Stainless Steel CeramicEdge Blade has a 1/100" (.25 mm) blade cut. Stainless steel blades are preferred by veterinarians for surgery prep as they are less likely to rust or discolor from frequent use of strong disinfectants. See the Instructions tab for additional tips on care and use.
Blade sets should be oiled once a day minimum! Ideally, it should be done before every grooming. After oiling, be sure to use a soft, dry cloth to wipe any oil off the external surfaces to reduce the possibility of getting it on the animal's coat. If the clipper blades leave streaks or slow down, it's a sure sign that the blades need oil.
Oiling Blades: Place a few drops of blade oil on the front and side of the cutter blades. Wipe excess oil off blades with a soft, dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are an excellent clipper blade coolant.
Cleaning Blades: Immerse blades only while clipper is running in a shallow pan of clipper oil or blade cleaner. After cleaning, turn the clipper off and dry blades with a clean, dry cloth. If blades will still not cut, there may still be some hair trapped between the upper and lower blade. Remove the blade off the clipper and slide the upper blade to one side without loosening the tension spring or moving the upper blade completely out from under the tension spring. Wipe the surfaces of the blades clean with a dry cloth, then place a drop of clipper oil where the upper and lower blades meet and also in the guide slot of the tension spring.
Always replace broken or nicked blades to prevent injury.
 VIEW ALL PRODUCTS BY Andis |
|
|
|
|
|
|
|
|
